FAQs for Electric Showers (MX Options Solo QI)
Water does not flow when turned on.
Six things to check:
- Check the mains circuit breaker and/or fuse.
- Check the isolation switch in the bathroom.
- Check the power from the isolation switch to the unit.
- Check the mains water supply.
- Check that the valve is open.
- Check the inlet filter.
If there is still no hot water, contact the service line on 0845 505 2211.
Water too hot.
Six possible reasons:
- Lower the temperature on the heat dial.
- Clean the showerhead of any dirt and debris, then restart the shower on the Hot water setting.
- Confirm that the mains water stop valve is fully open.
- Clean the inline filter.
- Ensure the isolation valve is fully open.
- Try using a lower heat setting.
If the water is still too hot, contact Customer Care on 0845 505 2211.
Water temperature is cycling through hot/cool.
Insufficient water flow. See the installation instructions.
Water too cool or cold.
Five things to check:
- Check the power selection setting is on Hot.
- Confirm there is sufficient water pressure.
- Clean the showerhead of any dirt and debris, then restart the shower on the Hot water setting.
- Lower the flow of water.
- Check to see if the auto reset light is permanently on.
If there is still no hot water, contact Customer Care on 0845 505 2211.
Water is dripping from the bottom of the shower unit.
Three possible reasons:
- The safety pressure relief device may have operated. Remove the showerhead and check that the water flows freely through the hose, clearing the system. Once this has been done, a new pressure relief device will need to be fitted. Contact the service line on 0845 505 2211.
- Check the mains water connections.
- Clean the showerhead of any dirt and debris and, if necessary, replace the showerhead and hose. Once this has been done, a new pressure relief device will need to be fitted. Contact the service line on 0845 505 2211.
The filter or showerhead keeps blocking or filling up with solid materials.
After the initial installation, no solid materials should remain in your cold water supply or the electric shower unit. Contact your plumber, as there may be a problem with your water supply.
The shower hose or showerhead is damaged, leaking or otherwise unsatisfactory.
Contact Customer Care on 0845 505 2211 and they will advise you of a suitable replacement.
My electric shower is out of the warranty period and is no longer working.
Contact Customer Care on 0845 505 2211 and they will advise you.
Auto reset light comes on (if fitted).
The temperature in the electric shower has exceeded the safe maximum, so the unit has automatically shut down one or both of the elements. When a safe temperature returns, the element turns back on.
Power setting will not remain on the setting I have selected.
This is a safety feature to reduce the risk of scalding, and is most likely caused by low water flow. Check all the solutions in “Water too hot” above, particularly point 2.
Phased shutdown light comes on (if fitted).
This is a feature of the shower: when the power is turned off, cold water flows through the unit for a few seconds to flush out the hot water and cool the elements.
If the light remains on, or comes on when the on/off button has not been pressed, contact Customer Care on 0845 505 2211.
